Field Installation and Service Manual IMS106 | Page 7

Step 5
Measure, Cut and Install Bottom Fillers for Wall Cabinets
5.1
Measure the wall condition at the back corner
and at the front of a cabinet side directly behind the Wall
Filler.
106
5.2
Typically, this wall condition will require a ta-
pered cut.
Make the scribe cut as described in 3B of this IMS. Do
not cut the piece to fi nal length until this scribe cut is
completed.
5.3
Tap the fi ller into place and secure. If the fi ller fi ts snug and
is less than 4” wide, use 1-1/4” fi nish nails through the inside bottom
of the cabinet angled into the fi ller.
Securing a Properly Fitted Bottom Filler
If the Bottom Filler is larger than 3” wide or does not fi t snug in its
opening, use a cleat mounted to the side of the wall cabinet to help
secure it.
35
1-1/4”
18 ga.
Finish Nail
Bottom Filler
Wider Than 3”
1-1/4”
18 ga.
Finish
Nail
©2017 PCS Professional Cabinet Solutions. All Rights Reserved.
Section 1: IMS 106
7