Chemwatch : 4883-43 Version No : 3.1.1.1
Page 6 of 14 Fido ' s Herbal Shampoo
Issue Date : 12 / 20 / 2013 Print Date : 07 / 05 / 2016
Body protection
Other protection
Thermal hazards other protective equipment , to avoid all possible skin contact .
Contaminated leather items , such as shoes , belts and watch-bands should be removed and destroyed . Wear general protective gloves , eg . light weight rubber gloves .
See Other protection below
No special equipment needed when handling small quantities .
OTHERWISE : Overalls . Barrier cream . Eyewash unit .
Not Available
Recommended material ( s )
GLOVE SELECTION INDEX
Glove selection is based on a modified presentation of the : " Forsberg Clothing Performance Index ". The effect ( s ) of the following substance ( s ) are taken into account in the computer-generated selection : Fido ' s Herbal Shampoo
Material BUTYL NEOPRENE VITON NATURAL RUBBER PVA
CPI
* CPI - Chemwatch Performance Index A : Best Selection B : Satisfactory ; may degrade after 4 hours continuous immersion C : Poor to Dangerous Choice for other than short term immersion NOTE : As a series of factors will influence the actual performance of the glove , a final selection must be based on detailed observation . - * Where the glove is to be used on a short term , casual or infrequent basis , factors such as " feel " or convenience ( e . g . disposability ), may dictate a choice of gloves which might otherwise be unsuitable following long-term or frequent use . A qualified practitioner should be consulted .
A A A C C
Respiratory protection
Type A-P Filter of sufficient capacity . ( AS / NZS 1716 & 1715 , EN 143:2000 & 149:2001 , ANSI Z88 or national equivalent )
Where the concentration of gas / particulates in the breathing zone , approaches or exceeds the " Exposure Standard " ( or ES ), respiratory protection is required . Degree of protection varies with both face-piece and Class of filter ; the nature of protection varies with Type of filter .
Required Minimum Protection Factor
Half-Face Respirator
up to 10 x ES A-AUS P2 -
up to 50 x ES -
Full-Face Respirator
A-AUS / Class 1 P2
Powered Air Respirator
A-PAPR-AUS / Class 1 P2
up to 100 x ES - A-2 P2 A-PAPR-2 P2 ^
^ - Full-face A ( All classes ) = Organic vapours , B AUS or B1 = Acid gasses , B2 = Acid gas or hydrogen cyanide ( HCN ), B3 = Acid gas or hydrogen cyanide ( HCN ), E = Sulfur dioxide ( SO2 ), G = Agricultural chemicals , K = Ammonia ( NH3 ), Hg = Mercury , NO = Oxides of nitrogen , MB = Methyl bromide , AX = Low boiling point organic compounds ( below 65 degC )
-
SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
Appearance Clear green fragranced viscous liquid ; mixes with water .
Physical state |
Liquid |
Relative density ( Water = 1 ) |
1.025-1.040 |
Odour |
Not Available |
Partition coefficient n-octanol / water |
Not Available |
Odour threshold |
Not Available |
Auto-ignition temperature (° C ) |
Not Applicable |
pH ( as supplied ) |
Not Available |
Decomposition temperature |
Not Available |
Melting point / freezing point (° C )
Not Available Viscosity ( cSt ) Not Available
Initial boiling point and boiling range (° C ) |
Not Available |
Molecular weight ( g / mol ) |
Not Applicable |
Flash point (° C ) Not Applicable Taste Not Available Evaporation rate < 1 Explosive properties Not Available
Flammability Not Applicable Oxidising properties Not Available
Upper Explosive Limit (%) |
Not Applicable |
Surface Tension ( dyn / cm or mN / m ) |
Not Available |
Lower Explosive Limit (%) |
Not Applicable |
Volatile Component (% vol ) |
Not Available |
Vapour pressure ( kPa ) Not Available Gas group Not Available