ECET 105 Week 1 iLab Introduction to Laboratory Test Equipment ECET 105 Week 1 iLab Introduction to Laboratory Te | Page 4

9. Launch the ELVIS II+ frequency generator.
1. Connect the frequency generator output to the oscilloscope CH0 input.
2. Select the square wave output (
5. Set the Amplitude to 5.00 Vpp and the DC Offset to 2.50 V.
6. On the oscilloscope, adjust the Time/Div setting to a value of 0.5 ms.
7. Set the Volts/Div to 2.0 V.
) and set the frequency to 1 kHz.
8.
Press Run on both instruments. Sketch the observed waveform below. Label both axes
and ground.
Output Waveform for Step 4
1. Stop both instruments.
5. Generate and measure triangle waveforms.
2.
Set the frequency generator to output a triangle wave ( ) with a frequency of 1.0 kHz,
6.00 Vpp, and 0 V DC Offset.
3. Set the oscilloscope to 2.0 V/div and 200 μsec/div.
4. Run both instruments and sketch the output below. Label the axes and ground.
Output Waveform for Step 5
1.
Measure and record the values below, including units.
Vertical scale _____________ Horizontal scale______________
Period ________________ Frequency _________________
1. Stop both instruments.
6. Generating and measuring sinusoidal waveforms.
6. Select a sine wave output with a frequency of 1 kHz, 6.0 Vpp, and 0 V DC Offset.
7. Record measurements displayed on the oscilloscope display, including units.