APPENDIX F:
INSTRUCTIONS FOR USE
SETTING UP THE DRESSYBARS:
1. Pull down the bars and let them settle at their resting angle (approximately 15 degrees upward).
2. Lift up the clip rod until it is perpendicular with the board and place the hasp through the hole in
its connecting piece, then turn the hasp 90 degrees so the rod stays in place. It is normal for the
rod to settle a bit. At this stage the device should look as shown in Figure 32.
Figure 32: The DressyBars in the set up position
3. Mount the shirt on the the end of the bars by placing one armhole and the body of the shirt
through each bar with the neck of the shirt facing away from you and the front of the shirt facing
down.
4. Attach the clip hanging from the clip rod by pincing a section of shirt near the neck hole, a
section at the middle, and a section near the bottom of the shirt and clipping them all together. At
this stage, the device is ready for dressing, as shown in Figure 33.
Figure 33: Shirt mounted on the DressyBars
35