1

3

AJPE TFX 96 , TFX2000 & TFX

2002 OIL PAN Moroso introduces Part No .

1 20056 , an AJPE TFX 96 , TFX

2000 & TFX 2002 Aluminum Wet Sump Funny Car Oil Pan . This oil pan features an “ L ” shaped billet aluminum , o-ringed oil pan rail for strength on the track and in the pits during repeated installation and removal . It ’ s fabricated aluminum sump is 4.25 ” Deep to 6.25 ” Deep in the back , has Internal baffling that keeps oil contained in pickup area during hard acceleration and de-acceleration . Baffling also increases pan ’ s lower-end strength to prevent “ ballooning ” during engine failures . Features a Removable windage tray built into oil pan and a -20 AN pickup .

GM LS / LT SPARK PLUG WIRE HEAT SHIELDS , 8 PACK

Moroso introduces Part No . 2

72953 , 8 pack of GM LS / LT Spark Plug / Ignition Wire Heat Shields . Fits Moroso and O . E . M .

2

GM LS / LT Wire sets with straight spark plug boots , O . E . M . quality similar to ACDelco Part No . 8006 . Shields protect spark plug boots from excessive heat for a longer life . They can be used on a new build or as cost effective replacement to freshen up an older engine with broken or missing shields

REMOTE SINGLE BATTERY CABLE KIT , SCREW TOGETHER TERMINALS

3

Moroso introduces Part No .

74020 , a Remote Single Battery

Cable Kit with Screw Together Terminals . This kit features Heavy Duty / High Voltage 1 Gauge Cable and easy to use , no crimping required Screw Together Battery Terminals and Ring Terminals . Kit includes 15 feet of Positive 1 Gauge Cable with red insulation , 3 feet of Negative 1 Gauge Cable with black insulation , insulation resists most car fuels , oils and cleaners . One Positive and One Negative Screw Together Battery Post Terminals

with one compression nut each . Two Screw Together 1 Gauge 3 / 8 ” Ring Terminals with one compression nut each and 4 Shrink Sleeves .

MULTI-INLET BREATHER TANKS , COMPACT , BILLET ALUMINUM

4

Moroso introduces Part Nos .

85396 and 85397 , Compact

Multi-Inlet Billet Aluminum Breather Tanks . These tanks have an overall height of 7 ” tall with the breather installed and are 2-¼ ” diameter , so they are able to be mounted in areas where a normal size breather tank wouldn ’ t fit or be desired .

The compact breather tanks are machined out of billet aluminum and are two pieces , the bodies of the compact breather tanks unscrew for cleaning and draining . The breather tanks feature internal baffling with mesh media for superior separation of air and oil . Each tank has an included non-hooded , clamp – on style , filtered breather and a mounting bracket . Top of the breather tanks have two -8AN Female bungs 180 Degrees apart from each other , included are two -8AN Male fittings , other sized fittings can be adapted as well if desired . Exterior of the tanks are available with either a polished or black anodized finish .

4