156
minimum load recommendations.
‡ Refer to driver or controller specifications for a compatible junction box.
‡‡ See fixture specifications for maximum series run limits.
§ See inline accessories specifications for maximum amperage ratings.
§§ See fixture specifications for a compatible adapter cable.
^ Install a compatible dimming control or switch. See the Electronic Dimmable
Driver / Dimmer Compatibility List for compatible dimming controls. See
the dimming control manufacturer installation guide for complete wiring
instructions.
^^ Load the driver at least 60% of the labeled load for proper
dimming performance (required for dimmable installations only).
Plug-In Adapter With DC Accessory Diagram
OMNIDRIVE® Electronic Dimmable Driver Diagram
Compatible Dimming Control
or On/Off Switch ^
OMNIDRIVE Dimmable Driver ^^
L
AC Power
50/60Hz
N
N
L V+
N V−
GND*
Some dimmers may require an
additional neutral wire connection.
V−
V+
V−
LED Tape Light / Fixture‡‡
V+
Class 2 Low Voltage
Plug-In Adapter (Driver)
AC Power
50/60Hz
DRIVER DIAGRAM TECHNICAL NOTES
* Driver may not require a fault ground connection. Refer to driver specifications
for additional information.
** Install a compatible Class 2 constant voltage driver. It is recommended to
load the driver no more than 80% of its labeled rating for maximum longevity.
*** Install a Class 2 constant voltage driver compatible with a low-voltage PWM
controller. It is recommended to load the driver no more than 80% of its labeled
rating for maximum longevity.
**** Determine the number of low-voltage outputs of the driver when installing
multiple PWM controllers/dimmer switches. No more than one PWM controller/
dimmer switch can be attached to a single output of the driver.
† Install a compatible magnetic low-voltage dimmer switch. See dimmer switch
manufacturer installation guide for complete wiring instructions.
†† Dimmable drivers require a compatible magnetic low-voltage dimmer
switch to supply the driver and fixture with appropriate input voltage. Do
not test or install directly connected to an AC power source or on/off switch.
It is recommended to load the driver no more than 80% of its labeled rating
for maximum longevity. See dimmer switch manufacturer specifications for
Inline Accessory§
(Extensions, splitters, controls, etc.)
Insertion points for
DC Accessories
LED Tape Light/Fixture‡‡
Strip Light DC
Plug Connector§§