Forth step
Cut the bait in half make sure to do it longways and not the tail part after it is sliced in half we
are ready for the thru wire.
Fifth step
Either cut out or burn out the pattern for which the thru wire will go the
are where it should be cut out is in the orange trace it with a pen or
marker
Sixth step
After fitting the thru wire in the bait put wither job weld or wood glue on the half that has the
pattern for the thru wire burned out and lightly cover the other side. Then connect the two
and do your best to clamp them together. Make sure to clamp them as tight as possible.
Seventh step
After the glue has dried take a knife and cut the glue that has oozed out. Then sand it so it is
as smooth as the rest of the lure.