DOORS & WINDOWS
Step-by-step skylight installation
»»
SINCE 2004 , SUNSQUARE HAS been pioneering skylight designs , always aiming for the highest possible specification .
As the first and only flat roof skylight manufacturer in the world to have its entire skylight range Kitemarked , it comes as no surprise that they have paid close attention its skylight installation process too .
Sunsquare has , since it started 12 years ago , sold separate upstands . It is the only company to have done so and that persistence is now being recognised and will become an industry standard .
A separate upstand not only ensures the expensive roofing membrane stays intact , but also ensures the roofer and skylight manufacturer can offer a comprehensive warranty .
Here is a step-by-step guide to installation :
Press the tape down firmly with your fingers to confirm full adhesion .
3 .
STEP THREE
Carefully lower the SkyView skylight onto the upstand , being careful not to trap your fingers between the upstand and skylight frame .
Check that the skylight is sat soundly onto the upstand , the frame should be continuously supported on all sides .
6 .
TOP
STEP SIX
Install the screw cover trims by first locating the bottom edge , then rotate the trim upwards .
Correct installation will be achieved when you hear the trim “ snap ” into position .
As each section is installed check alignment at the corners , making small adjustments with a soft faced mallet as required .
1 .
STEP ONE Check the pre-installed upstand dimensions prior to lifting the skylight onto the roof area .
It is important to confirm that the upstand is square . This is achieved by comparing measurements taken across the diagonally opposite corners . If the upstand is square these dimensions will be the same .
4 .
STEP FOUR
Carefully adjust the position of the skylight making sure it is correctly centred over the aperture .
Before moving onto the next step it is advisable to check the positioning of the skylight from the inside , as this will allow for easy fixing of the internal finishes .
7 .
STEP SEVEN
To ensure the screw cover trims are firmly located it is advisable to lightly tap the profile along its length with a soft faced mallet . By doing so you can be sure that the profile is fully engaged .
8 .
2 .
STEP TWO
Make sure that the top face of the upstand is clean , dry and free from undulations . Apply the skylight bedding tape ( supplied ) to the full perimeter of the upstand , along the outer edge .
5 .
STEP FIVE Using the supplied screws fasten the skylight to the upstand through the pre-drilled holes . Be careful not to over-tighten these screws as you risk deforming the aluminium frame .
STEP EIGHT
This completes the installation of the Sunsquare SkyView skylight . You are now able to remove all protective films for disposal .
Thoroughly clean the newly installed skylight using a proprietary glass cleaner and a soft lint free cloth .
www . sunsquare . co . uk
34 » JUL 2016 » CLEARVIEW-UK . COM