Ariston Manual Products manual book MWKA 424 | Page 41

U s e
s e t t i n g t h e b r i g h t n e s s o f t h e d i s p l a y
Programming
Display
E N
You can adjust the brightness of the display.
Set the time to 00:10.
Press and hold the ENTER button for 5 seconds.
-CO- is shown in the display.
Adjust the brightness using the + / - knob.
Confirm by pressing the ENTER button.
M a i n t e n a n c e & C l e a n i n g
We recommend that you clean the oven
regularly and remove any deposits of food
inside and outside of the appliance. Use a damp
sponge and a little soap. If the appliance is not
cleaned regularly, its surface could become
damaged, permanently affecting the appliance’s
lifespan and possibly causing a safety hazard. If
the door or door seal are damaged, the oven
should not be used until it has been repaired by
a qualified person.
support with the drive spindle, make sure you do
not let water get into the motor spindle orifice.
Remember to put back the support, the support
wheels and the turntable.
Do not clean the appliance with a steam
cleaner.
The use of abrasive products, alcohol or
thinners is not recommended as they are likely
to damage the appliance.
Do not use abrasive maintenance products or
hard metal scrapers to clean the oven door as
they may scratch the surface or break the glass.
If the oven smells bad or is dirty, boil a cup of
water with lemon juice for 2 minutes and clean
the walls with a small amount of washing up
liquid.
To clean the top of the cavity, remove the grill
element (Fig. 1).
Unhook the grill element by pushing on the pin in
the top left (Fig. 2).
The turntable can be removed for easy cleaning.
To remove it, pick it up using the access zones
provided for this purpose. If you take out the
Fig. 1
Fig. 2
1 9