American Motorcycle Dealer AMD 231 October 2018 | Page 31
RWD Fenders and Highway Bar
Available exclusively through Drag Specialties, these
fenders by Murietta, California based manufacturer
Russ Wernimont Designs (RWD) and made from
heavy-gauge steel, with each fender inspected
individually to ensure straightness, consistency and
a “flawless finish with an absolute minimum of
finishing bodywork.” Each fender is pre-drilled for
easy bolt-on installation.
Also seen here, the ready-to-paint RWD Flat Back
Front Dresser Fender has been laser trimmed to
complement the rake of the bike. A direct bolt-on
design, no spacers are required.
The RWD 8.5” OEM-style Dyna rear fender is a one-
piece, stamped 14-gauge construction,
laser-trimmed for a precise fit with minimal paint
prep. Welded wire tube for clean wire installation,
the fender mount and license plate bracket holes are
predrilled and also has taillight cutout for traditional
taillight mounting.
This RWD highway bar/skid plate design with
footrests is made in 1 3/4” steel tubing and stamped
14-gauge steel plate with a gloss black powder coat
finish.
Measuring approximately 34” wide x 12” tall, it has
high impact plastic “Revolver” end caps that double
as footrests. It ships with all necessary mounting
hardware (not for use with evaporative emissions
canister or Big Bear motor mounts).
Highway bar/skid plate with foot rests
Custom dresser fender
PARTS AND ACCESSORIES
8.5” OEM style
Dyna Fender
Flat back dresser
front fender
DRAG SPECIALTIES
Janesville, Wisconsin, USA
Tel: 608 758 1111
[email protected]
www.dragspecialties.com
www.russwernimont.com
Platinum ‘Simple’ FLH/T Air
Ride Package
Fullerton, California based Platinum Air
Suspension has new FLH/T Front ‘Pucks’ and
Rear Air Ride Package.
Platinum Air owner Mike Feris says “these
allow the rider to control their ride height
with positive lift without going all the way
down the rebound control route with our
Bleed Feed system. This simple system is
available for most H-D V-Twins – the side
mounted shock gives up to 4.25 of lift.”
The kit includes two air cylinders, machined
from 6061 T-6 billet aluminum; two 41mm
or 49mm pucks; air-control valve; DOT
approved 1/4 line and fitting; switch
harness; air compressor; hardware and line
cutter. For bike models 1985 to current.
The kit delivers a minimum retracted height
of 9.25” and maximum extended of 13.5”,
rear lift of 4.25”, 4.25” shock travel with a
diameter of 2.5”. ABS applications may vary
due to installation, and the system comes
www.AMDchampionship.com
PARTS AND ACCESSORIES
complete with one year warranty. There is
now an option to choose between chrome
and black - everything is blacked out from
the cylinder to the rod.
PLATINUM AIR SUSPENSION
Fullerton, California, USA
Tel: 714 871 2424
[email protected]
www.platinumairsuspension.com
AMERICAN MOTORCYCLE DEALER - OCTOBER 2018
31