American Motorcycle Dealer AMD 181 August 2014 | Page 27

PRO GUIDE Mustang seats for 'Breakout' MUSTANG has extended its seat range with new options designed exclusively for the ’13-14 Softail Breakout model. The new seats are versions of the company’s existing Tripper Fastback that have been reworked to suit the wider tire configuration of the CVO Breakout. Both of the new seats offer a 13in front width for the driver and a 7in wide rear. The only difference in the two designs is that one is plain finish, while the other has tuck and roll. “Our Tripper Fastback offers a super clean, custom style, well suited for the lines of the Breakout,” says Mustang’s Marketing Director, Marilyn Simmons. “It is cut low for the rider and offers good back support.” MUSTANG MOTORCYCLE PRODUCTS Three Rivers, Massachusetts, USA Tel: 413 668 1100 [email protected] www.mustangseats.com Retro style inverted hand controls KUSTOM Tech’s Retro Inverted handlebar levers are constructed from forged brass and offered in a choice of chrome with a polished brass lever, satin chrome with a satin brass lever, or all raw brass. For use on 1in handlebars with a 21.5mm internal diameter, the controls are right-side for the brake and left for the clutch. KUSTOM TECH Monteoriolo Impruneta, Firenze, ITALY Tel: +39 055 208204 [email protected] www.kustomtech.eu Kickstand for lowered FLs PINGEL Enterprise has recognized that increasing numbers of riders are running lowered front and rear suspension of FL models for comfort due to the bikes having tall seats, and to improve the bike’s handling. However, the company is also aware that this change makes the stock kickstand too long to hold the bike at a safe angle, and to resolve this issue it has in production a specific replacement kickstand. The Pingel kickstand for lowered FLs has been designed to work on bikes that have had the front lowered 2in and the rear 1in. Manufactured from TIG welded steel and then powder coated black, the Pingel part fits the stock location and reuses the OEM spring. Unlike the stock H-D kickstand, the Pingel part has a large surface foot pad contact area to support the bike better on the ground. The kick tab is also easily accessible for use with stock and oversized primary covers. It is designed specifically for ‘07‘14 FL models, and will also fit years back to ‘84, but lean angles may vary. Throttle housing clamps SUPERTRAPP has released a range of new throttle bodies under its JayBrake brand. The throttle housing clamps are designed to clean up a bike’s handlebars when an upgrade has been made to aftermarket hand controls. The throttle housings are available for push-in or threaded style throttle cables, and with a left side spacer to fill the void when a switch housing is not being used. Machined from billet aluminum, they are designed for use on 1in handlebars. SUPERTRAPP Cleveland, Ohio, USA Tel: 216 265 8400 [email protected] www.jbrake.com PINGEL ENTERPRISE INC. Adams, Wisconsin, USA Tel: 608 339 7999 [email protected] www.pingelonline.com www.AMDchampionship.com AMERICAN MOTORCYCLE DEALER - AUGUST 2014 27