CRADLE TO GRAVE •
4. Consider using motorised drive pulleys Motorised pulleys offer energy advantages and weight savings and open up space for belt cleaner installation and maintenance. Since all rotating components( including the main bearings) are located inside the pulley, the external stub shafts need minimal space to be mounted to the structure.
5. Consider professionally trained installation Belt cleaners must be mounted accurately, typically within a few millimetres, to operate optimally and reduce the risk of damaging the belt. Partnering with the belt cleaner supplier guarantees proper installation with minimal adjustments and ensures that the new chute maintains a clean, professional appearance.
X = Distance between top and bottom runs of the conveyor belt.
Y = The vertical distance between the top run of the conveyor belt on the Head pulley and the tangent point where the belt leaves the Head pulley and starts the return run.
Structural, spatial, and safe access considerations can present limitations.
Calculating the adequate belt tension A critical design requirement is to determine the amount of wrap around the drive pulley necessary to ensure adequate torque conversion from the drive into belt tension sufficient to move the belt without slipping. It is interesting to note that the fundamental relationship describing this transfer does not depend on the pulley diameter, but rather on the coefficient of friction, µ, between the belt and pulley, the wrap angle, and the belt tensions required to prevent slip [ Figure 4 ].
Figure 5 – Secondary mounting location basic layout.
Some secondary cleaners must be installed at least 50mm from the point where the belt leaves the head pulley, so this offset should also be considered if needed. Additionally, the X dimension must be verified against the idler dimensions to ensure sufficient installation space [ Figure 6 ].
Figure 4 – Drive pulley tension relationship.
Secondary belt cleaner location geometry Assumption: Top and bottom runs of the conveyor belt( X) are parallel, entering the head pulley and leaving the snub pulley [ Figure 5 ].
A similar analysis of the placement of precleaners indicates that with a 1 200mm diameter head pulley, two primary cleaners can be installed alongside a secondary cleaner. The inclusion of tertiary cleaners is possible but may not be necessary if two precleaners and a secondary are mounted on the head pulley.
Variables: ϴ = Wrap angle of belt around head pulley. ω = Wrap Angle, ϴ,- 180 degrees. H = The height of the opening for the secondary belt cleaner blades and frame installation. Rh = Radius of head pulley plus lagging, plus belt thickness. Rs = Radius of snub pulley plus lagging, plus belt thickness.( Snub pulley diameter default value: 0.64 × head pulley diameter per DIN 22101).
T = The width off the opening for the Secondary belt cleaner blades and frame installation.
W = Length of belt segment tangent to both the head and snub pulleys.
Figure 6 – Secondary mounting space example.
www. africanmining. co. za African Mining Publication African Mining African Mining • November 2026 • 43