OPTIMISING BELT CLEANER POSITION ON MINING CONVEYORS
CRADLE TO GRAVE •
OPTIMISING BELT CLEANER POSITION ON MINING CONVEYORS
By R Todd Swinderman, P. E., President Emeritus, Martin Engineering, Past President of CEMA
All images supplied by Martin Engineering
Figure 1 – Secondary and tertiary cleaners are all specially designed to clear the belt of hidden fines that could create dust along the return.
Mines across Africa struggle with conveyor carryback piling under
the system, causing dust, cluttering walkways, and restricting access for maintenance. At the conveyor system discharge zone in a mining operation, the location and number of belt cleaners needed for efficient production volume are directly linked to safety, emissions, and operating costs.
A common design issue is positioning belt cleaners in the optimal locations. Structural, spatial, and safe access considerations can present limitations. The configuration of discharge chutes and the installation of a dribble chute to capture extra discharge may also need to be factored into the design. This article will discuss design calculations for the placement of secondary cleaners.
Figure 2 – Proper placement depends on several factors, with the main being the pulley diameter.
Design and installation considerations There are many simple options designers should consider: 1. Is the drive pulley wrap angle really needed, or are you just applying it from habit? A common default wrap is 210 degrees, created by the position of the snub pulley. The gap between the head pulley and snub pulley is an ideal location for a secondary cleaner, but the combination of pulley diameters and wrap angle may make mounting a secondary cleaner difficult and maintenance nearly impossible. We recommend utilising an updated engineering design program that uses either the DIN or CEMA methods for calculating accurate tension values and the required wrap angle.
2. Consider using a larger diameter head pulley Choosing a head pulley based on the minimum diameter may seem like it saves money, however, MSHA reports that up to 85 % of maintenance problems are due to fugitive materials, which increase costs for cleanup, labour, and equipment replacement. 1 A larger head pulley can allow the installation of two cleaners in the primary position and enough snub pulley space for one or two cleaners in the secondary position, significantly reducing the amount of fugitive material [ Figure 3 ].
CEMA recommendations, placement and positioning The Conveyor Equipment Manufacturers Association( CEMA) defines the secondary position as the space between the head pulley and the snub pulley on the return run of the belt [ Figure 2 ]. Unfortunately, structural designs often result in a very short section of belt surface between the head pulley and the snub pulley, which is the ideal location for many secondary cleaner designs. This limited distance leaves little room for belt cleaners in the secondary position, which is further complicated by the space needed for a dribble chute. Additionally, designers often place work platforms based on major components, overlooking access for belt cleaner inspection or maintenance. Belt cleaners typically require more attention than major components to ensure system efficiency because the blades are wearing components that must be maintained at optimal cleaning pressures [ Figure 2 ].
Figure 3 – Larger than minimum head pulley diameter for adequate belt cleaning with two primaries and one secondary cleaner.
3. Place a priority on ergonomic access to the belt cleaners Maintenance personnel can spend up to a third of their time simply gaining access to equipment. Designing access to seldominspected or-maintained components based on minimum walkway codes increases costs. Consider structures and work platforms that facilitate belt cleaner inspection and maintenance.
www. africanmining. co. za African Mining Publication African Mining African Mining • November 2026 • 41