HIGH STAKES AT AN EVEN HIGHER ALTITUDE
By Heleen Katja Tshibumbu, Journalist & Technical Writer
VEGA’ s 80GHz radar solution brought stable level measurement to the world ' s highest diamond mine.
TECHNOLOGY •
All images supplied by Vega Instruments
In the Maluti Mountains of Lesotho, southern Africa, sits the world ' s highest diamond mine, 3 200 metres above sea level. It ' s a punishing place to work, with heavy snowfall, temperatures swinging from-18 ° C to + 20 ° C, and relentless wind. The ore preparation process is no gentler. The mine pulls ore to the surface through two kimberlite pipes. That source rock is crushed and processed to extract diamonds, but the yield is small and less than two carats per hundred tons of rock. Getting to those diamonds takes serious effort.
Separating diamonds from kimberlite In a Dense Media Separation( DMS) plant, powdered ferrosilicon is suspended in water to create a fluid with the same density as diamond. Crushed diamond-bearing material is added, separating the heavier minerals from the lighter rock. The result is a concentrate that ' s typically less than 1 % of what went into the plant.
An alternative is centrifugation, where dense material is spun through cyclones at varying speeds. Diamonds and other heavy minerals get pressed against the cyclone walls and forced out the bottom, while wastewater rises through the centre and is drawn off and screened.
Each method has trade-offs – a DMS plant costs roughly ten times more to build than a cyclone system, but delivers better yields at the cost of higher water consumption and operating expenses.
That ' s a real problem for level measurement technology.
And regardless of which technology is used, results still come down to operator skill. What keeps a DMS plant, and the whole process behind it, running smoothly is a high level of automation paired with measurement technology that can be trusted to deliver accurate readings.
Turbulence complicates level measurement Conditions inside a diamond mine are brutal, and dust is everywhere. That ' s a real problem for level measurement technology. In the flotation tank, the level of the flotation liquid carrying the enriched material needs to be measured precisely. But the medium enters the tank through pipes from multiple directions, creating heavy turbulence and splashing.
An older 26GHz radar sensor installed there years earlier experienced some challenges. Dust and debris built up on the antenna, triggering false readings again and again. Radar is a non-contact technology and should be well-suited to dirty environments, but under these extreme conditions, the sensor simply couldn ' t keep up.
80GHz technology brings stability
VEGA ' s South African team recommended replacing the old sensor with the new VEGAPULS. Its 3 ° beam angle was the key: a much tighter focus that could separate the real measurement signal from interference caused by the inlet pipes. Combined with a dynamic range of 120dB, the sensor brought a level of accuracy, repeatability and reliability the application hadn ' t seen before. Temperature and pressure swings don ' t affect the readings, and neither do changes in the liquid ' s density or viscosity, a critical advantage given how inhospitable conditions at the mine can get.
The sensor operates across a pressure range of-1 bar to + 20 bar and process temperatures from-40 ° C to + 200 ° C. Despite its shorter wavelength, the 80GHz sensor is largely unaffected by buildup or condensation. www. africanmining. co. za African Mining Publication African Mining African Mining • November 2026 • 21