African Mining July 2025 | 页面 31

HEALTH AND SAFETY • equipment supplier should overview the designs, offer feedback and supervise the installation. Either outside contractors or in-house personnel can be used. Sufficient downtime must be allocated to properly modify the conveyor.
Measuring results from improvements is important and relatively easy to do. Photos and videos of before and after must be taken. Dust levels are measured using common instrumentation, spillage can be measured by placing buckets or trays in appropriate locations and carryback is measured by placing a tarp under several return idlers close to the discharge pulley. The collected fugitive materials are weighed for comparison after the conveyor has been modified. Dust and spillage sampling locations should be marked so the tests can be accurately repeated after retrofitting and an improvement percentage can be calculated.
The length of time for collecting samples can vary from a day to a week and should give a good representation of the average or typical operating environment and weather conditions. It is important to keep the dust monitor running even if the conveyor is running empty, as maximum fugitive dust levels are often detected when running conveyors empty long enough that the carryback dries out and becomes airborne.
© 2025 Martin Engineering
The Martin Conveyor Belt Carryback Gauge is a patented tool for estimating carryback on the return side of a conveyor belt.
Usually, the results of the pilot programme are immediately noticeable, but there is a temptation to assume the problem has been solved and to revert back to delaying maintenance without follow-up maintenance, causing the results to deteriorate. Therefore, the test period should extend to the next scheduled maintenance shutdown with periodic inspections and adjustments made by the equipment supplier in the interim to ensure optimum efficiency.
The payback on training To demonstrate the benefit of safety to a company’ s bottom line,
www. africanmining. co. za African Mining Publication African Mining African Mining • July 2025 • 29