• HEALTH AND SAFETY
A properly designed conveyor controls emissions for improved safety and easier maintenance.
All images © Martin Engineering 2025
DESIGNING CONVEYOR RETROFITS FOR PRODUCTION AND SAFETY
Todd Swinderman, president emeritus, Martin Engineering, makes a case for designing safety into a system rather than merely training safety, showcasing innovations that drastically improve safety that can be retrofitted into almost any belt conveyor system.
Conveyors are among the fastest and potentially dangerous cargo transport systems at a bulk handling operation. Even though their safety and performance are critical to the operation’ s success, the impact of their contribution to overall efficiency is often unrecognised by management and workers alike. Operational basics of belt conveyor systems are too often a mystery to those employees who have little understanding about the hardware installed and the performance required from the components.
The knowledge gap is understandable. The attention of personnel at a bulk handling operation is centered on logistical and scheduling concerns. The“ care and feeding” of belt conveyors – i. e., the adjustment, maintenance and troubleshooting – make a huge difference in safety and performance but is typically outside of operator’ s expertise. It’ s not that they don’ t care about conveyors,
The consensus among safety professionals is that the most effective way to mitigate risks is to eliminate the hazard by design. but the ongoing maintenance and service of these systems is often usurped or deprioritised for other issues.
Low-bid process and life cycle cost Although the policy is generally not explicitly stated by companies, the Low-Bid Process is usually an implied rule that is baked into a company’ s culture. It encourages bidders to follow a belt conveyor design methodology that is based on getting the maximum load on the conveyor belt and the minimum compliance with regulations using the lowest price materials, components and manufacturing processes available.
Maximising the volume of cargo and minimising the price of the system usually means choosing the narrowest feasible belt, operating at the highest speed possible. This leaves little margin for error and in many cases results in chute plugging, excessive spillage and reduced equipment life.
When companies buy on price, the benefits are often short-lived, and costs increase over time, eventually resulting in losses. In contrast, when purchases are made based on the lowest long-term cost( life-cycle cost), benefits usually continue to accrue and costs are lower, resulting in net savings over time.
26 • African Mining • April 2025 www. africanmining. co. za