576 8-2. Steps to take in an emergency
WARNING
lKeep back from the tire while it is being repaired, as there is a chance of it bursting while the repair operation is being performed. If you notice any cracks or deformation of the tire, turn off the compressor switch and
stop the repair operation immediately.
lThe repair kit may overheat if
operated for a long period of time. Do not operate the compressor continuously for more than 40 minutes.
lParts of the repair kit become hot during operation. Be careful handling the repair kit during and after operation. Do not touch the metal part connecting the bottle and the compressor. It will be extremely hot.
lDo not attach the vehicle speed warning sticker to an area other than the one indicated. If the sticker is attached to an area where an SRS airbag is located, such as the pad of the steering wheel, it may prevent the SRS air bag from operating properly.
n Driving to spread the liquid sealant evenly
Observe the following precautions to reduce the risk of accidents.
Failing to do so may result in a loss of vehicle control and cause death or serious injury.
lDrive the vehicle carefully at a low speed. Be especially careful when turning and cornering.
lIf the vehicle does not drive straight or you feel a pull through the steering wheel, stop the vehicle and check the following:
• Tire condition. The tire may have separated from the wheel.
• Tire inflation pressure. If tire inflation pressure is 19 psi( 130
kPa, 1.3 kgf / cm 2 or bar) or below, this may indicate severe tire damage.
NOTICE
n When performing an emergency repair
lPerform the emergency repair without removing the nail or screw that has punctured the tread of the tire. If the object
that has punctured the tire is removed, repair by the emergency tire puncture repair kit
may not be possible.
lThe repair kit is not waterproof.
Make sure that the repair kit is not exposed to water, such as
when it is being used in the rain.
lDo not put the repair kit directly
onto dusty ground such as sand at the side of the road. If the
repair kit vacuums up dust, etc., a malfunction may occur.
lMake sure the sealant bottle of the repair kit is in a vertical position. The repair kit does not operate properly when it is laid.
n Precautions for the emergency tire puncture repair kit
lThe repair kit power source should be 12 V DC suitable for
vehicle use. Do not connect the repair kit to any other source.
lPlace the repair kit in a storage to prevent it from being exposed to dirt or water.
lStore the repair kit in the luggage compartment out of reach of children.