242 5-3. Operating the lights and wipers
surroundings. This may cause the low beams to remain on or the high beams to flash or dazzle pedestrians or vehicles ahead. In such a case, it is necessary to manually change between the high beams and low beams.
• When there are lights similar to headlights or tail lights in the surrounding area
• When headlights or tail lights of vehicles ahead are turned off,
dirty, changing color, or not aimed
properly
• When the headlights are repeatedly changing between the high
beams and low beams.
• When use of the high beams is
inappropriate or when the high beams may be flashing or dazzling pedestrians or other drivers.
• When the vehicle is used in an area in which vehicles travel on the opposite side of the road of the country for which the vehicle was designed, for example using a vehicle designed for right-hand traffic in a left-hand traffic area, or vice versa
• When it is necessary to disable the system: �P. 249
• Situations in which the sensors may not operate properly: �P. 254
n Temporarily reducing front camera sensitivity
The sensitivity of the front camera can be temporarily reduced.
1 Turn the power switch off with the following conditions met.
lThe headlight switch is in the or position.
lThe headlight switch lever is in the low beam position.
lThe Automatic High Beam switch is on.
2 Turn the power switch to ON.
3 Within 60 seconds after performing step 2, push the headlight
switch lever to the high beam position then pull it to the original position quickly 10 times, then leave the lever in its original position.
4 If the sensitivity is changed, the Automatic High Beam indicator will blink 3 times.
Turning the high beams on / off manually
n Changing to the high beams
Push the lever forward.
The AHB indicator will turn off and the high beam indicator will turn on.
Pull the lever to its original position to enable the Automatic High Beam system again.
n Changing to the low beams
Press the Automatic High Beam switch.
The AHB indicator will turn off.
Press the switch to enable the Automatic High Beam system again.