8-2. Steps to take in an emergency
625 sensors are operational, this indication may disappear by itself.
■ If“ System Stopped Front Camera Low Visibility See Owner’ s Manual” is displayed
Indicates one of the following systems is disabled.
● PCS( Pre-Collision System)
● LDA( Lane Departure Alert)
● LTA( Lane Tracing Assist)
● LCA( Lane Change Assist)
● AHB( Automatic High Beam)
● Dynamic radar cruise control
● RSA( Road Sign Assist)
● PDA( Proactive Driving Assist)
Follow the following correction methods.
• Using the windshield wipers, remove the dirt or foreign matter from the windshield.
• Using the air conditioning system, defog the windshield.
• Close the hood, remove any stickers, etc. to clear the obstruction in front of the front camera.
■ If“ System Stopped Front Camera Out of Temperature Range
Wait until Normal Temperature” is displayed
Indicates one of the following systems is disabled.
● PCS( Pre-Collision System)
● LDA( Lane Departure Alert)
● LTA( Lane Tracing Assist)
● LCA( Lane Change Assist)
● AHB( Automatic High Beam)
● Dynamic radar cruise control
● RSA( Road Sign Assist)
● PDA( Proactive Driving Assist)
Follow the following correction methods.
• If the front camera is hot, such as after the vehicle is parked in the sun, use the air conditioning system to decrease the temperature around the front camera.
• If a sunshade was used when the vehicle was parked, depending on its type, the sunlight reflected from the surface of the sunshade may cause the temperature of the front camera to become excessively high.
• If the front camera is cold, such after the vehicle is parked in an extremely cold environment, use the air conditioning system to increase the temperature around the front camera.
■ If“ System Stopped Front Radar Sensor Blocked Clean Radar Sensor” is displayed
Indicates one of the following systems is disabled.
● PCS( Pre-Collision System)
● LTA( Lane Tracing Assist)
● LCA( Lane Change Assist)
● Dynamic radar cruise control
● PDA( Proactive Driving Assist)
Follow the following correction methods.
• Check if there is any foreign matter attached to the radar sensor or radar sensor cover and clean
them if necessary.( �P. 261)
8
When trouble arises