Active Lane Change Assist( if equipped)
� Continued from previous page
- Old lane markings remain.- Avoiding parked vehicles- Snow, puddles or snow melting agents remain on the road surface.- Cracks or constructed traces remain on the road surface.- Frozen roads, snow-covered roads or other slippery road surfaces
The tires may spin, causing loss of control of the vehicle.- Entering a sharp curve into an interchange or junction, or a service area, parking area, toll booth or other facilities
- Visibility is poor due to sand, smoke or water vapor blowing in the wind, or the front vision is obscured due to water splashes, snow, dirt or dust stir up generated by the vehicle in front or oncoming traffic.
- The stereo camera’ s field of view is obstructed by fogging, snow, dirt, frost, dust, scratches, or smears on the windshield, or by light reflecting off the dirt, etc.
- Rain or dirt has not been fully wiped off of the windshield. There is a risk that the stereo camera may not detect the lanes.
- The stereo camera’ s field of view is obstructed( for example by a canoe on the roof of the vehicle).
• The stereo camera may have difficulty detecting the lane markings under the following conditions and the system may not operate properly.- At night or in a tunnel without the headlights on- In bad weather( for example, rain, snow or thick fog)- The road surface is wet and shining by reflected light.- There are other traffic markings on the lane you are driving in( arrows, words, etc.).- The distance between your vehicle and the vehicle in front is short, making it difficult to detect lane markings.- A vehicle intruded from a neighboring lane or the vehicle in front changed lanes.- The shape of a curve in the road suddenly changes.- Shadows of guardrails or similar objects are overlapped on the lane markings.- Strong light is coming from the front( sunlight or headlight beams of oncoming traffic, etc.).- The width of a lane is either too narrow or too wide.- The width of a lane has changed.
190