2019-2020 Program Guide 2019-2020 | Seite 940

10-482-008 (LTC 10-482-132) TURBINE MAINTENANCE ...prepares learners to climb, inspect and service wind turbines; use torque fasteners; check gearbox lubrication; add grease to moving and exposed parts; verify good electrical connections; perform an overall “system check” and routine maintenance ona wind energy system; in addition to fault determination and troubleshooting. Students will incorporate wind industry best safety practices, must be prepared to climb multiple times in a day, and work full days outside in varying weather conditions. Prerequisites: 10-620-110 AC Fundamentals, 10-620- 138 Programmable Controllers-Allen Bradley, 10-620-104 Fluid Power 2 and 10-804-113 College Tech Math 1A or 10-804-115 College Tech Math 1 and Co-Requisites: 10-482-124 Wind Technician 3 Lab 10-482-103 WIND FARM INTERNSHIP ...will allow learners to develop skill portfolios through hands-on training in the installation, maintenance and/or troubleshooting of wind energy systems. Students will work with their employers to ensure safe and proper techniques while working on and around wind turbines and ne-tuning their electromechanical skills. Internship opportunities vary in availability and location throughout the United States. Travel is required. 10-482-003 (LTC 10-482-124) WIND TECHNICIAN 3 LAB ...certi es learner in torque tool techniques with Snap-on tools. Students will apply safe and proper techniques while using various styles of torque wrenches and adapters including hand torque and hydraulic torque wrenches. Students will demonstrate pro ciency in performing a variety of maintenance functions on the GE 1.5 nacelle including oil lter changes, generator brush maintenance, and brake pad replacement while following proper safety and LOTO procedures. (Co-Requisites: 10-482-106 Wind Technician 2 - Safety and Maintenance) 10-620-122 MECHANICAL SYSTEMS 2 ...mechanical drive system components related to multiple shaft drives, heavy-duty V-belt drives, synchronous belt drives, lubrication, and alignment. (Corequisite: 10- 620-121, Mechanical Systems 1) 10-620-123 MECHANICS 3: SYSTEMS ...application of correct couplings to mechanical systems, heavy- duty chain drives, maintenance of brakes and clutches, selection of brake/clutch mechanisms, and speci cation of linear ball bushings and ball screw drives. (Prerequisite: 10-620-122, Mechanics 2: Intermediate) 10-620-161 POWER ELECTRICITY 1: MOTORS ...This course provides the opportunity for the student to develop the knowledge, skills, process and understanding of: Causes and results of magnetism and magnetic elds, laws of magnetic/electric interactions, DC Series, Permanent Magnet, Shunt, and Compound motor performance and operating characteristics. 10-664-160 CONTROL 1: DISCRETE SYSTEMS ...applications and utilization of digital input and output devices through connection to and programming of PLC's. (Prerequisite: 10-664-101, Automation 2; 10- 664-102, Automation 3: PLC) 10-664-161 CONTROL 2: INTRODUCTION TO SERVO SYSTEMS ...introduction to components and operational functions of servo systems. Control of servo systems using PLC programming. (Corequisite: 10-664-160, Control 1: Discrete Systems) 10-664-162 CONTROL 3: SERVO MOTION SYSTEMS ...creation of PLC programming to complete basic motion tasks. (Corequisite: 10-664-161, Control 2: Servo Systems-Intro) 930